西门子资料专区

简介：
问题： 怎样在 SIRIUS 软起动器3RW40中为触点13/14参数设置 RUN 模式？ 解答： 怎样在 SIRIUS 软起动器3RW40中为触点13/14参数设置 ON / RUN 模式： RUN 参数化： - 只要 Device LED (绿色) 在闪烁，则按下 RESET MODE /MAN 按钮 (时间 > 2s)。 - 保持 RESET MODE / MAN 按住不放，然后同时按下 RESET / Test 按钮(时间 > 1s)。然后 LED Device 状态变为 ON (红色) 且 LED STATE / BYPASSED 慢速闪烁 (触点13/14 为 ON 模式)。 - 释放这两个按钮 然后再次按下 RESET MODE / MAN 按钮 (时间 > 1s)。LED DEVICE 为 ON 且 LED STATE / BYPASSED 快速闪烁 (触点13/14为 RUN 模式)。 - 释放 RESET MODE / MAN 按钮 之后必须保存 RUN 状态。请按下 RESET / TEST 按钮 (时间 > 1s)。 SIRIUS 软起动器3RW40参数现在已更改为 RUN 功能。 ON / RUN 功能说明： ON = 当软起动器得到起动信号时，触点13/14闭合 RUN = 除得到起动信号时间内，当软起动器运行处于软停止状态时，触点13/14也闭合 条目号:23685079 日期:2006-08-04 QUESTION: How can one parameterize RUN mode for contact 13 / 14 at SIRIUS Softstarter 3RW40 ? ANSWER: How to parametrize the ON / RUN contact 13/14 of SIRIUS Softstarter 3RW40: RUN parametering: - Press button RESET MODE /MAN >2sec. as long as Device LED is (green) flickering - Then press simultaneously to button RESET MODE / MAN the button RESET / Test for >1s. The LED Device status is then (red) ON and the LED STATE / bypassed flashing (contact13/14 ON-Mode). - release both buttons Then press again button RESET MODE / MAN for >1s. LED DEVICE is ON and LED STATE / BYPASSED flickering (contact 13/14 is in RUN-Mode). - release button RESET MODE / MAN After this the RUN-State must be saved. Please press the button RESET / TEST for >1s. SIRIUS Softstarter 3RW40 parameters have now changed to function RUN. Description ON / RUN-Function: ON = contact 13 / 14 is closed as the ON-Command is active on terminal 13/14 RUN = contact 13 / 14 is closed too at soft stop mode is running Entry ID:23685079 Date:2006-07-19